Step 1 – Take your preferred soft lure, a Lure Loop, and a Rigged Bottom Jig – Size #0/1.

Step 2 – Hold the Lure Loop at the ‘loop’ end, and carefully screw it into the head of your lure.

Step 3 – Carefully thread your Rigged Bottom Jig through the Lure Loop then rig the Lure as you usually would.

Step 4 – You’re ready to go. After your next bite, the Lure head will now easily slide down the hook avoiding any damage to the lure and is easy to slide back into position.

Remove the Weight – Holding the hook at the loop, carefully pull the weight off the wire.

Make Note of the Wire Location – Once the weight is removed, remember the position of the wire on the hook.

Thread the Wire through the Hook Loop – A new wire can be installed as per this image.

Refer to Image 2 for the Wire Location – It is important that the wire is correctly installed.

Position New Weight – Ensure the number on the weight is readable. This is important as the two holes in the weight are not the same size.

Push the Wire Through the Weight – This is how a correctly installed weight should look.